1-3/4" Staggered Dual Exhaust Systems For 1958-1964 Swingarm Panheads
An outside-the-frame front pipe, and a rear pipe that routes in front of the transmission, guarantee classic style and a throaty sound. These complete systems fit all 1948–1964 Panhead engines in swingarm frames, and will also fit rigid frames if the mechanical brake crossover tube is removed. The 40"-long drag pipes and the pipe sets with mufflers, have slider channels to ease installation.
722A 34"-long Goose Cut drag pipes (use Paughco #’s 725B and 725D clamps to install) shown below on bike
722 34"-long Slash Cut drag pipes (use Paughco #’s 725B and 725D clamps to install)
722-40 40"-long Slash Cut drag pipes
722M 38"-long Slash Cut muffler set
722GM 38"-long Goose Cut muffler set
722TM 38"-long Tapered muffler set
422R Rear heat shield for Paughco #722 series pipe sets (shown below on bike)
Special
Notes
:1) Drag pipes are not recommended for use on the street
.2) These pipes have less ground clearance than original equipment and may scrape on hard right hand turns
. Do not use these pipes unless the front end is extended at least
4" longer than stock or serious injury may result
.3) See page
247 for
P-clamps and frame rail clamps to install these pipe sets
.