Staggered Dual Exhaust Systems For 1966 - 1969 Swingarm Shovelheads
An outside-the-frame front pipe, and a rear pipe that routes in front of the transmission, guarantee classic style and a throaty sound. These complete systems fit all 1966–1969 Shovelhead engines in swingarm frames, and will also fit rigid frames if the
mechanical brake crossover tube is removed. The 40"-long drag pipes and the pipe sets with mufflers, have slider channels to ease installation.
2"-DIAMETER DRAG PIPES
723-2IN40 40"-long Slash Cut drag pipes (use Paughco #725D clamps to install) not shown
1-3/4"-DIAMETER EXHAUST SYSTEMS
723 34"-long Slash Cut drag pipes (use Paughco #725D clamps to install) not shown
723A 34"-long Goose Cut drag pipes (use Paughco #725D clamps to install) shown below on bike
723-40 40"-long Slash Cut drag pipes
723M 38"-long Slash Cut muffler set
723GM 38"-long Goose Cut muffler set
723TM 38"-long Tapered muffler set
422R Rear heat shield for Paughco #723 series pipe sets (shown below on bike)
Special
Notes
:1) Drag pipes are not recommended for use on the street
.2) These pipes have less ground clearance than original equipment and may scrape on hard right hand turns
. Do not use these pipes unless the front end is extended at least
4" longer than stock or serious injury may result
.3) See page
247 for
P-clamps and frame rail clamps to install these pipe sets
.