Shovelhead Staggered Dual Exhaust Systems For 1966 - 1969

1-3/4" Staggered Dual Exhaust Systems For 1966 - 1969 Shovelheads
With a standard outside the frame front pipe, these exhaust systems were designed to fit 1966–1969 Shovelhead engines in swingarm frames, but will also fit rigid frames with mechanical brakes. The 40"-long drag pipes and the muffler sets have slider channels to ease installation.

724 34"-long Slash Cut drag pipes (use Paughco #725D clamps to install)
724A 34"-long Goose Cut drag pipes (use Paughco #725D clamps to install)
724-40 40"-long Slash Cut drag pipes (shown on bike)
724M 38"-long Slash Cut muffler set
724GM 38"-long Goose Cut muffler set
724TM 38"-long Tapered muffler set
424R Rear heat shield for Paughco #724 series pipe sets (not shown)

 

Special Notes:
1) Drag pipes are not recommended for use on the street.
2) These pipes have less ground clearance than original equipment and may scrape on hard right hand turns. Do not use these pipes unless the front end is extended at least 4" longer than stock or serious injury may result.
3) See page 247 for P-clamps and frame rail clamps to install these pipe sets.