1-3/4" Panhead Shotgun Exhaust Systems For 1948 - 1964
All of these exhaust sytems are for rigid framed Panheads with kickstart ONLY. They all have slider channels to ease installation (except the 34"-long drag pipes), and heat shields are recommended for the rear pipe.
721D34 34"-long Slash Cut drag pipes (use Paughco #’s 725B and 725D clamps to install)
721D40 40"-long Slash Cut drag pipes
721DGM 38"-long Goose Cut muffler set
721DM 38"-long Slash Cut muffler set (shown below on bike)
721DTM 38"-long Tapered muffler set
411BR Rear heat shield for Paughco #721D series pipe sets (shown below on bike)
Special
Notes
:1) Drag pipes are not recommended for use on the street
.2) These pipes have less ground clearance than original equipment and may scrape
on hard right hand turns
. Do not use these pipes unless the front end is extended at least
4" longer than stock or serious injury may result
.3) See page
247 for
P-clamps and frame rail clamps to install these pipe sets
.4) See pages
349-353 for photos of the heat shields for these pipe sets
.